CREATIVE CENTER TABLE WITH BICYCLE RIM

CREATIVE TABLE WITH BICYCLE RIM

Center Table With Bicycle Rim.....

Here we will see how we can use the old and waste bicycle rim to make out a beautiful and very creative center table where you can enjoy a coffee mug with your lover.








NEED TOTAL THREE RIMS....for this table

Here we will see the step by step procedure to create a dynamic, stylish, durable and very cheap center table with the useless bicycle rims.

We will see the steps of making table of the following design but you can make many different design with your own creativity.

The steps are as follows ...

Step 1 :- Take three rims of a bicycle, then take out all the spokes of two rim and then cut the two rims from the middle so that we can have four   semi-circular rims.

Without spokes the rim would be look like as shown in the figure, if you want you may paint then also according to the walls of your home.

Cut the rim from the middle but you must take care the that both the rims must be cut from the middle as shown in the figure.

After we cut the rim into two semi-circular rim we will going to have the pair of rim as shown in the figure ( figures are only to give idea not an actual figure).

Step 2 :- Now join the pair of semi-circular rim (with out spokes) as shown in the figure you can use leather thread and rectangular chair feet rubber for this purpose.

This is rectangular chair feet rubber which can be use to join the pair of semi-circular rims.

Step 3 :- Now join all the four semi - circular rims. Now you have a structure like a stand.

Step 4 :- Now put the third rim with is full rim with spokes if you want you may color the rim and use different creative colors for spokes.And put the rim over the stand and join it with screws or a steel wire but take care the wire or screw must not be very much visible.

There will be no need to make extra holes in the rim , it actually have the holes by its own as shown in the figure.

Step 5 :- Now measure the radius of the inner circle of the rim and bring the glass of the same size which can be fitted with in the inner circle of the rim and here the spokes of the rim will support the glass of the table.

This is the radius of the circle. 

<3 <3 ... your feedback is very important for me ... <3 <3